The Navigation panel is the area where all the major modes can be found. The command panel is part of the Information panel and is the location where the controls related to the Information panel can be found. In the information panel all functions and visualisation related to the selected modus are displayed and can be found. Also machine indicators can be found here. In this area you can find logo information, which product is loaded, the active bend, selected subdirectory and (when activated) the service row. In the top the title panel is always shown. The structure of the main screen is as follows: Just by tapping the various modes, the specific mode will be selected. The above main screen will appear having the Products function active. The DA-Touch control’s main screen looks as follows:ĭepending on the navigation button which is active, the screen will differ. This user manual focuses on the control software and related machine functions.Īt the right side of the control a USB port is available for connection of external devices, such as a memory stick or an external keyboard or mouse. A description of the functions and available touch controls is given in the next sections of this manual, aside of the description of the specific functions. Operation of the control is mainly done over the touchscreen. The precise outfit of your control may vary. Part1 - Operation Overview and General Introduction This manual is valid for software version 1.1 and higher. Software version Manual version Description V1.1 V0215 first issue V1。 The following overview shows the relation between software and manual versions. This manual is also updated as a result of changes in the control software. The control software is updated regularly to increase performance and add new functionality. No part of this publication may be copied or reproduced without written permission from Delem BV. Delem reserves the right to change this manual without prior warning. This manual does not entitle you to any rights.This manual mainly describes the operation of the Delem DA58T controller and is meant for operators who are instructed for operation of the total machine. Offering easiest CNC programming based on the Delem graphical touch screen user interface including automatic bend sequence calculation and collision detection. The DA-58T is a state-of-the-art complete 2D graphical control solution for synchronized press brakes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |